TM 9-2320-272-24-1
Align fan blade (32) with fan clutch holes (34) and install six washers (31) and nuts (30). Tighten
2.
nuts (30) 36 lb-ft (47 Nm).
Remove two screws (27) from fan clutch (29).
3.
Coat screw (27) threads with antiseize compound and install screws (27) on fan mounting bracket (26).
4.
Install top half of shroud (2) on radiator (17) with five screws (4), six washers (3), and two new
5.
locknuts (16). Finger tighten screws (4).
Secure halves of shroud (2) and (8) with eight washers (6), four screws (7), and new locknuts (6).
6.
Tighten five screws (4) and two locknuts (16).
7.
Install two new sets of isolators (12) in brackets (18) and (23).
8.
Install spacer (19) and bracket (23) on bracket (18) and radiator (17) with two screws (13), washers (14),
9.
snubbing washers (26), and new locknuts (24). Finger tighten locknuts (24).
Install two new lockwashers (20) and screws (21) on bracket (23) and radiator (17). Tighten screws (21)
10.
40 lb-ft (55 Nm). Bend tabs on lockwashers (20) against flats of screws (21).
Tighten locknuts (24) 35 lb-ft (50 Nm).
11.
FOLLOW-ON TASK: Start engine (TM 9-2320-272-10) and run until fan clutch locks up. Check fan for
alignment.
3-189
