15-44. CEILING FILLER AND SIDE PANELS REPLACEMENT
THIS TASK COVERS:
c. Right Side Panel and Filler Installation
a. Left Side Panel and Filler Removal
b. Right Side Panel and Filler Removal
d. Left Side Panel and Filler Installation
INITIAL SETUP
EQUIPMENT CONDITION
APPLICABLE MODELS
M820, M820A2
Van body sides fully expanded and secured
(TM 9-2320-260-10).
TOOLS
Fluorescent light fixtures removed (para. 15-92).
General mechanic's tool kit
Blackout and emergency light fixtures removed
(Appendix B, Item 1)
Blackout switch removed (TM 9-2320-260-20).
MATERIALS/PARTS
Ceiling rear cover removed (para. 15-41).
Fibrous glass felt insulation
3-phase receptacles and 400 Hz receptacles
removed (TM 9-2320-260-20).
Telephone jack removed (left side)
PERSONNEL REQUIRED
(TM 9-2320-260-20).
Two
Cord box removed (TM 9-2320-260-20).
Registers and deflectors removed (para. 15-38).
REFERENCES
TM 9-2320-260-10
GENERAL SAFETY INSTRUCTIONS
TM 9-2320-260-20
Gloves, eyeshields, and dust mask must be worn
TM 9-2320-260-34P-2
during ceiling filler and side panel replacement.
WARNING
1. Remove seventy-nine screws (6) and side panel (5) from van ceiling (3), air ducts (4), and
transition (7).
2. Remove three screws (1) and filler (2) from transition (7).
b. Right Side Panel and Filler Removal
1. Remove seventy-nine screws (10) and side panel (11) from van ceiling (3), air ducts (4), and
transition (7).
2. Remove five screws (9) and filler (8) from transition (7).
NOTE
Insulate entire structure with fibrous glass felt insulation.
c. Right Side Panel and Filler Installation
1. Install filler (8) on transition (7) with five screws (9).
2. Install side panel (11) on van ceiling (3), air ducts (4), and transition (7) with seventy-nine
screws (10).
15-166
