TM 9-2320-260-34-2
15-37. HINGED ROOF MAINTENANCE (Contd)
NOW
Insulate areas of dissimilar metal-to-metal contact with zinc
q
chromate primer.
Seal between exterior joints with sealing compound.
q
Apply adhesive to both rubber and metal surfaces.
q
Perform step 1 only if skin was replaced (subtask c.).
q
Assistant will help with step 1.
q
Install skin (7) on hinged roof frame (11) with one hundred fifty-seven new rivets (8).
1.
2.
Install four new rubber bumpers (10) on hinged roof frame (11) with four screws (9).
3.
Install two clevises (18) on bars (15) and (25) and position in slots of hinged roof frame ( 11).
4.
Install latch (17) on hinged roof frame (11) with four washers (20) and nuts (21).
5.
Install two clevises (18) on latch (17) with two pins (16) and new cotter pins (19).
6.
Install
new O-ring (36), new gasket (6), plate (5), and handle (3) on skin (7) with two screws (4).
7.
Install
handle (3) on latch (17) with washer (22), new locknut (23), and new cotter pin (24).
8.
Install
angle bracket (37) on skin (7) with three screws (38).
9.
Install
chain hook (1) and padlock and chain (2) on angle bracket (37).
Install new seals (31) and (32) on hinged roof frame (11).
10.
Install new seal (35) and retainer (33) on hinged roof frame (11) with fifty-two new rivets (34).
11.
12.
Install new cushion pads (12) and (27) on hinged roof frame (11).
13.
Install new seal (28) and retainer (30) on hinged roof frame (11) with twenty-four new rivets (29).
Install new seal (13) and hinge (14) on hinged roof frame (11) with sixty-nine screws (26).
14.
15-148
