TM 9-2320-260-34-1
8-6. TRANSMISSION MAINTENANCE (Contd)
NOTE
Apply sealing compound to gaskets before installation.
Install new gasket (10), new gasket (7), and bell housing (6) on transmission (8) with seven new
55.
lockwashers (4) and nuts (3).
Install new seal (11) and plug (30) in bell housing (6).
56.
Position clutch release shaft (14) in bell housing (6).
57.
Position clutch release yoke (25) on clutch release shaft (14).
58.
Install two spacers (22), new lockwashers (23), and screws (24) on clutch release yoke (25).
59.
Install bearing (26) on clutch release sleeve (28).
60.
Install clutch release sleeve (28) over input shaft (9) and on clutch release yoke (25) with two spring
61.
clips (5), pads (29), four new lockwashers (2), and screws (1).
Install new gasket (21) and inspection cover (19) on bell housing (6) with six new screw-assembled
62.
lockwashers (20).
Install two elbows (12) on bell housing (6).
63.
Install two grease cups (13) on two elbows (12).
64.
Install grease fitting (27) on clutch release sleeve (28).
65.
Install new woodruff key (18) and lever (15) on clutch release shaft (14) with screw (16) and new
66.
locknut (17).
8-36
