TM 9-2320-260-34-1
8-6. TRANSMISSION MAINTENANCE (Contd)
39.
Install nut (16) on countershaft (14). Tighten nut (16) 550-600 lb-ft (746-814
40.
Install new cotter pin (18) through nut ( 16) and countershaft (14).
41.
Position spacer washer (15) on output shaft (13).
NOTE
Apply sealing compound to gaskets before installation.
42.
Install new gasket (17) and countershaft rear cover (19) on transmission case (3) with four new
lockwashers (20) and screws (21).
43.
Install new seal (22) on output shaft cover (11).
44.
Install new gasket (12) and output shaft cover (11) on transmission case (3) with four new lock-
washers (10) and screws (9).
Install shield (8) and companion flange (7) on output shaft (13) with nut (6). Tighten nut (6)
45.
500-550 lb-ft (678-746
46.
Install new cotter pin (23) through nut (6) and output shaft (13).
8-33
