TM 9-2320-260-34-1
8-5. TRANSMISSION (OUT-OF-VEHICLE) REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
MATERIALS/PARTS (Contd)
All
Six lockwashers
(vehicles with transmission PTO)
TOOLS
(Appendix D, Item 215)
General mechanic's tool kit
Gasket sealant (Appendix C, Item 42)
(Appendix B, Item 1)
REFERENCES (TM)
Torque wrench, 3/8-in. dr.
TM 9-2320-260-34P-1
(Appendix B, Item 4)
Transmission lifting jack
EQUIPMENT CONDITION
MATERIALS/PARTS
Engine and transmission removed (para. 3-24).
Twelve lockwashers (Appendix D, Item 215)
GENERAL SAFETY INSTRUCTIONS
Gasket (Appendix D, Item 139)
Lifting capacity of transmission lifting jack must be
Gasket (vehicles with transmission PTO)
greater than weight of transmission.
(Appendix D, Item 134)
WARNING
Transmission lifting jack must have a lifting capacity greater than
the weight of the transmission to prevent damage to equipment
and injury to personnel.
1. Position transmission lifting jack under transmission (5).
2. Remove twelve screws (4) and lockwashers (3) from bell housing (2) and flywheel housing (6).
Discard lockwashers (3).
3. Remove transmission (5) and gasket (1) from flywheel housing (6). Discard gasket (1).
4. Position safety strap around transmission (5).
NOTE
Steps 5 and 6 apply to transmissions equipped with transmission
power takeoff.
5. Remove six nuts (9), lockwashers (8), power takeoff (10), and gasket (11) from transmission (5).
Discard lockwashers (8) and gasket (11).
NOTE
Perform step 6 if stud(s) is damaged.
6. Remove stud(s) (7) from transmission (5).
