TM 9-2320-260-34-1
3-57. REAR COVER AND OIL SEAL INSTALLATION
THIS TASK COVERS:
Installation
INITIAL SETUP
APPLICABLE MODELS
MATERIALS/PARTS
Gasket (Appendix D, Item 73)
All
Oil seal (Appendix D, Item 418)
TOOLS
Four lockwashers (Appendix D, Item 217)
General mechanic's tool kit
O-ring (Appendix D, Item 274)
(Appendix B, Item 1)
REFERENCES (TM]
Torque wrench, 3/8-in. dr.
TM 9-2320-260-34 P-1
(Appendix B, Item 4)
Oil seal driver (Appendix B, Item 84)
Installation
1. Install new gasket ( 10) and rear cover (9) on cylinder block (1) with eight screws (8). Finger tighten
screws (8).
2. Install four washers (3), new lockwashers (4), and screws (5) in oil pan (2). Finger tighten screws (5).
3. Install new O-ring (6) in rear cover (9).
4. Using seal driver, install new seal (7) in rear cover (9).
5. Tighten eight screws (8) and four screws (5) 24-29 lb-ft (33-39 Nm).
