TM 9-2320-260-34-1
Table 2-1. Mechanical Troubleshooting (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 2. Check for broken piston or piston rings in power steering assist cylinder.
a. Replace piston, piston rings, or seals if broken or defective (para. 12-7).
b. If steering wheel is still hard to turn, proceed to step 3.
Step 3. Check front axle for defective steering knuckle bushings (para. 10-3). Replace steering
END OF TESTING!
AIR COMPRESSOR
55. LOW AIR PRESSURE (NO AIR LEAKS, GOVERNOR PROPERLY ADJUSTED AND OPERATIVE)
Confirm low air gage reading. Tee in known good gage.
a. Replace air gage if test gage reads normal value (TM 9-2320-260-20).
b. Replace air compressor if test gage reads low air pressure (para. 11-3).
END OF TESTING!
56. AIR COMPRESSOR PASSES EXCESSIVE OIL (EXCESSIVE OIL BLED FROM AIR RESERVOIRS)
Slowly bleed and check reservoirs for evidence of oil (TM 9-2320-260- 10).
END OF TESTING!
57. AIR COMPRESSOR DOES NOT UNLOAD (AIR GOVERNOR ADJUSTED AND OPERATIVE)
Check unloader valve and unloader valve spring for wear and defects.
Replace unloader valve or spring if worn or damaged (para. 11-4).
END OF TESTING!
58. AIR COMPRESSOR HEAD LEAKING WATER
fittings correctly if necessary (TM 9-2320-260-20).
Step 2. Ensure screws securing head are at proper torque (TM 9-2320-260-20).
a. Tighten head screws if necessary (TM 9-2320-260-20).
b. Proceed to step 3 if compressor head still leaks coolant.
END OF TESTING!