TM 9-2320-260-34-1
Table 2-1. Mechanical Troubleshooting (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 2. Check front axle shafts and universal joints for defects (TM 9-2320-260-20).
Step 3. Check front-end alinement (TM 9-2320-260-20). Replace defective parts if front end cannot
be alined (paras, 10-2 through 10-4, and TM 9-2320-260-20).
END OF TESTING!
Check frame and suspension alinement (para. 13-6).
Replace defective parts if rear end cannot be alined (para. 10-5).
END OF TESTING!
STEERING GEAR
Step 1. Check steering knuckle condition for defects (malfunction 47, step 1).
Step 2. Check condition of steering gear and steering assist cylinder for defects.
a. Adjust steering gear if play is excessive (para. 12-6).
b. Replace steering gear if steering gear play remains excessive (para. 12-5).
END OF TESTING!
Complete troubleshooting malfunction 47, step 3 and malfunction 48.
END OF TESTING!
Check oil leak and verify location.
a. Repair or replace fittings if leaking (TM 9-2320-260-20).
b. Replace steering gear if defective (para. 12-5).
END OF TESTING!
Step 1. Check outlet fitting and reservoir O-rings for defects (TM 9-2320-260-20).
Step 2. Replace defective packing or lines (TM 9-2320-260-20).
END OF TESTING!
Replace power steering pump if defective (TM 9-2320-260-20).
END OF TESTING!
Step 1. Check power steering pump pressure (para. 12-6).
Replace power steering pump if pressure is abnormal (TM 9-2320-260-20).
