TM 9-2320-260-20
I
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
EQUIPMENT CONDITION
APPLICABLE MODELS
q Parking brake set (TM 9-2320-260-10).
All
q Hood raised and secured (TM 9-2320-260-10).
MATERIALS/PARTS
q Lower right panel (TM 9-2320-260-10).
Antiseize tape (Appendix C, Item 30)
Cooling system drained (para. 3-45).
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
NOTE
Close water manifold and engine oil cooler valves prior
q
to removal.
Have drainage container ready to catch coolant.
q
1. Remove two clamps (12) and hose (13) from elbow (14) and engine oil cooler valve (8).
2. Remove two clamps (2) and hose (3) from elbow (1) and water manifold valve (6).
3. Remove water manifold valve (6), elbow (4), and bushing (5) from water manifold (7).
4. Remove engine oil cooler valve (8), elbow (11), and bushing (9) from engine oil cooler (10).
5. Remove elbows (1) and (14) from personnel hot water heater (15).
1. Apply anti seize tape to male threads of water manifold valve (6), engine oil cooler valve (8), two
bushings (5) and (9), and elbows (4) and (11).
2. Install elbows (1) and (14) on personnel hot water heater (15).
3. Install bushing (9), elbow (11), and engine oil cooler valve (8) on engine oil cooler (10).
4. Install bushing (5), elbow (4), and water manifold valve (6) on water manifold (7).
5. Install hose (3) on elbow (1) and water manifold valve (6) with two clamps (2).
6. Install hose (15) on elbow (14) and engine oil cooler valve (8) with two clamps (12).
14-20
