TM 9-2320-260-20
I
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-260-10
All
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Two locknuts
Parking brake set (TM 9-2320-260-10).
Lockwasher
q
q Battery ground cable disconnected (para. 4-48).
1. Disconnect harness (5) from control box (4).
2. Remove locknut (1), clamp (2), and harness (5) from stud (3) on firewall (16). Discard locknut (1).
3. Disconnect fuel pump lead (13) from wire (14).
4. Disconnect harness (5) from personnel heater (12).
5. Remove locknut (8), screw (6), lockwasher (7), and ground wire (10) from bracket (9) and frame (11).
Discard locknut (8) and lockwasher (7).
6. Remove grommet (15) and harness (5) from firewall (16).
1.
Connect harness (5) on personnel heater (12).
2.
Connect wire (14) to fuel pump lead (13).
3.
Install ground wire (10) on bracket (9) and frame (11) with new lockwasher (7), screw (6), and
new locknut (8).
4.
Insert harness (5) through hole in firewall (16).
5.
Place grommet (15) around harness (5) and install grommet (15) on firewall (16).
6.
Connect harness (5) to control box (4).
7.
Install harness (5) and clamp (2) on stud (3) on firewall (16) with new locknut (1).
14-10
