TM 9-2320-260-20
THIS TASK COVERS:
a. Troop Seat Removal
e. Troop Seat Assembly
f. Cargo Rack Assembly
b. Cargo Rack Disassembly
g. Troop Seat Installation
c. Troop Seat Disassembly
d. Inspection
INITIAL SETUP
--
APPLICABLE MODELS
REFERENCES (TM)
M813, M813A1, M814
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Five cotter pins
Seven locknuts
Parking brake set (TM 9-2320-260-10).
q
q Side rack and troop seat removed
(TM 9-2320-260-10).
NOTE
Left and right side rack and troop seats are maintained basically
the same way for M813, M813A1, and M814 cargo trucks. This
procedure covers the left side rack and troop seat for M813A1.
Remove five cotter pins (4), pins (3), and troop seat (2) from cargo rack (1). Discard cotter pins (4).
Remove two locknuts (10), screws (9), four washers (8), and clamps (7) from cargo rack slat (5).
1.
Discard locknuts (10).
2. Remove sixteen nuts (12), screws (6), and five stakes (11) from two cargo rack slats (5),
1.
Remove five locknuts (13), screws (15), and legs (14) from three channels (18) and two end channels
(22). Discard locknuts (13).
2. Remove two nuts (25) and screws (16) from hinges (23) on end channels (22).
3. Remove four nuts (24), screws (21), two hinges (23), and end channels (22) from troop seat slats (17).
4. Remove twenty nuts (19), screws (20), three hinges (23), and five channels (18) from troop seat
slats (17).
1. Inspect legs (14), channels (18), end channels (22), and hinges (23) for cracks, bends, and excessive
rust. Replace legs (14), channels (18), end channels (22), or hinges (23) if damaged.
2.
Inspect cargo rack and troop seat slats (5) and (17) for splinters, warping, and excessive rotting.
Replace cargo rack and troop seat slats (5) and (17) if damaged.
12-2
