TM 9-2320-260-20
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODEM
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Lockwasher
Ten locknuts
Parking brake set (TM 9-2320-260-10).
Screw-assembled lockwasher
1.
Remove screw-assembled lockwasher (26), convex mimer (17), locknut (16), lockwasher (15),
screw (25), and two clamps (23) from brace (24). Discard screw-assembled lockwasher (26),
lockwasher (15), and locknut (16).
2.
Remove two locknuts (18), washers (19), spacers (20), and mirror (21) from brace (22). Discard
locknuts (18).
Remove two locknuts (10), washers (11) and (14), rod (30), and braces (22) and (24) from
3.
braces (12), (13), (27), (28), and (29). Discard locknuts (10).
Remove screw (8), washer (6), locknut (7), and braces (12) and (28) from clip (4). Discard locknut (7).
4.
NOTE
Assistant will help with step 5.
Remove two screws (32), locknuts (l), plate (2), and clip (4) from cowling (3). Discard locknuts (1).
5.
Remove locknut (7), washer (6), hinge bolt (9), and brace (29) from lower door hinge (31). Discard
6.
locknut (7).
7.
Install hinge bolt (9) in lower door hinge (31).
8.
Remove locknut (7), washer (6), hinge bolt (9), and braces (13) and (27) from upper door hinge (5).
Discard locknut (7).
9.
Install hinge bolt (9) in upper door hinge (5).
Install braces (13) and (27) on upper door hinge (5) with hinge bolt (9), washer (6), and new
1.
locknut (7).
2. Install brace (29) on lower door hinge (31) with hinge bolt (9), washer (6), and new locknut (7).
NOTE
Assistant will help with step 3.
3. Install clip (4) and plate (2) on cowling (3) with two screws (32) and new locknuts (1).
4. Install braces (28) and (12) on clip (4) with screw (8), washer (6), and new locknut (7).
11-76
