TM 9-2320-260-20
I
THIS TASK COVERS:
a. Arm Removal
d. Handle Installation
b. Glass Removal
e. Glass Installation
c. Handle Removal
f. Arm Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Nine screw-assembled lockwashers
Bumper
Parking brake set (TM 9-2320-260-10).
Adhesive (Appendix C, Item 2)
Wiper motor removed (para. 11-37).
Remove two screws (8) and spring washers (9) from arm (10), outer frame bracket (5), lever (11), and
glass frame bracket (15).
1. Remove seven screw-assembled lockwashers (21) and windshield hinge (3) from windshield outer
frame (4). Discard screw-assembled lockwashers (21).
2. Remove two seals (1) and seal (2) from windshield hinge (3). Remove seal (14) from windshield inner
frame (20).
1. Remove two screws (17), nuts (18), and handle (19) from windshield inner frame (20).
2. Remove bumper (16) from handle (19). Discard bumper (16).
3. Remove two screw-assembled lockwashers (6) and plate (7) from windshield outer frame (4). Discard
screw-assembled lockwashers (6).
4. Remove thumbscrew (13), washer (12), and lever (11) from arm (10).
I
I
d. Handle Installation
1.
Install lever (11) on arm (10) with washer ( 12) and thumbscrew (13).
2. Install new bumper (16) in handle (19).
3. Install handle (19) on windshield inner frame (20) with two screws (17) and nuts (18).
4. Install plate (7) on windshield outer frame (4) with two new screw-assembled lockwashers (6).
1. Apply adhesive to mounting side of hinge seals (1) and (2), and on hinge (3).
2. Install two hinge seals (1) and seal (2) on hinge (3).
3. Install seal (14) on windshield inner frame (20).
4. Install hinge (3) on windshield outer frame (4) with seven new screw-assembled lockwashers (21).
5. Install windshield inner frame (20) on hinge (3).
11-50
