TM 9-2320-260-20
THIS TASK COVERS:
c. Installation
a. Removal
b. Cleaning and Inspection
INITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-260-10).
All
MATERIALS/PARTS
GENERAL SAFETY INSTRUCTIONS
Keep fire extinguisher nearby when using
Gasket
Ten lockwashers
drycleaning solvent.
Drycleaning solvent (Appendix C, Item 29)
Rags (Appendix C, Item 22)
REFERENCES (TM]
TM 9-2320-260-10
TM 9-2320-260-20P
Remove ten screws (5), lockwashers (4), axle shaft (3), and gasket (1) from axle housing (2). Discard
gasket (1) and lockwashera (4).
b. Cleaning and Inspection
WARNING
Drycleaning solvent is flammable. and will not be used near open
flame. Use only in well-ventilated places. Failure to do so may
result in inquiry to personnel.
1. Clean all parts with drycleaning solvent, then dry each part with a clean rag.
2. Inspect axle shaft (3) for cracks, breaka, and bends. Replace axle shaft (3) if cracked, broken, or bent.
3. Inspect the splines of axle shaft (3) for nicks, burrs, cracks, and breaks. Remove minor nicks
and burra with a file or emery cloth. Replace axle shaft (3) if the splines are cracked or broken.
Position new gasket (1) on axle shaft (3) and install axle shaft (3) on axle housing (2) with ten new
lockwashers (4) and screws (5).
7-24
