TM 11-7440-293-14
4-82. REMOVING/INSTALLING MESSAGE ENTRY GROUP RACK. (CONT)
ACTION
REMARKS
ITEM
LOCATION
INSTALLATION
Message entry
Put message entry group rack on electronic
1. Center position
equipment table and aline holes.
group rack (1)
on electronic
and electronic
equipment table
equipment
table (2)
Install, handtighten.
Screw (3), flat
2. Lower supports
There are four screws. Step 1 is
washers (4) and
on message entry
typical for all four screws.
nut (5)
group rack
Do step 2 again.
Screws (6)
3.
4. Curbside, vertical
Screw (7), lock-
Install, handtighten.
washer (8) and
support
flat washer (9)
6. Roadside, vertical
Install, handtighten.
Screw (10), lock-
washer (11) and
support
flat washer (10)
NOTE
Using two 1/2-inch box wrenches, tighten all screws.
See paragraph 4-11 for installation.
6. Lower supports
4-inch ground
straps
NOTE
See TM 11-7440-251-10 and TM 11-7440-253-10-1 for
installation of message entry group
4-170
