TM 11-7440-293-14
4-16. PP-1104 POWER SUPPLY AND GUARD ASSEMBLY MOUNTING HOLES.
This task covers:
Preparation for drilling
INITIAL SETUP
Tools
Personnel Required
Felt-tip pen
One mechanic
Tape measure
Equipment Condition
Materials/parts
Angle brackets installed on
PP-1104 power supply
power supply.
ACTION
LOCATION
ITEM
REMARKS
NOTE
Set power supply 2 3/4 inches from curbside edge of floor
plate and 7 3/4 inches from forward wall. The angle bracket
mounting holes and guard assembly mounting holes will be
used as guides for marking.
1. Curbside, near
Mark (1)
Using felt-tip pen, mark.
forward wall
There are two angle brackets. Each
angle bracket has three mounting
holes. Step 1 is typical for all six
mounting holes.
2.
Marks (2)
Do step 1 again.
NOTE
Set guard assembly 3 inches in front of power supply and 6
inches from curbside wall.
3. In front of
Mark (3)
Using felt-tip pen, mark.
power supply
4.
Mark (4)
Using felt-tip pen, mark.
5. Curbside, near
Guard assembly
Remove.
forward wall
(5) and power
supply (6)
4-24
