TM 11-7440-293-14
Preparation instructions for drilling are given in this section.
Tacfire rack mounting holes
Power supply and guard assembly mounting holes
Pipe nipple and 30-inch ground strap mounting holes
90 cable connector mounting hole
Curbside antenna cables mounting holes
Roadside antenna cables mounting holes
4-15. TACFIRE RACK MOUNTING HOLES.
This task covers:
Preparation for drilling
INITIAL SETUP
Tools
Personnel Required
Felt-tip pen
Two mechanics
Tape measure
Equipment Condition
Materials/parts
Tacfire rack assembled.
Assembled tacfire rack
All heat vents closed.
ACTION
LOCATION
ITEM
REMARKS
NOTE
A helper will be needed to lift tacfire rack into position.
For better visibility and location of marked areas, clean
area being marked and use a felt-tip pen or marker. The
radio mount mounting holes and wall support mounting holes
will be used as guides for the areas being marked. Set
tacfire rack against forward wall 12 inches from roadside
wall measuring from radio mount.
1. Radio mount
Mark (1)
Using felt-tip pen, mark.
There are eight mounting holes.
Step 1 is typical for all eight mounting
holes.
2.
Mounting holes (2)
Do step 1 again.
4-22