• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WRECKER BOOM SUPPORT REPLACEMENT (M816, M819) cont'd
WRECKER HOIST WINCH BLOCK REPLACEMENT (M816, M819) cont'd

TM-9-2320-260-20 5-Ton 6x6 M809 Series Trucks (Diesel) Truck Cargo: 5-Ton 6x6 M813 (2320-00-050-8902) (EIC:BSB); Manual
Page Navigation
  1037    1038    1039    1040    1041  1042  1043    1044    1045    1046    1047  
TM 9-2320-260-20
13-39. WRECKER HOIST WINCH BLOCK REPLACEMENT (M816, M819)
THIS TASK COVERS:
a. Direct Block Removal
c. Pulley Block Removal
b. Direct Block Installation
d. Pulley Block Installation
INITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
M816, M819
q Parking brake set (TM 9-2320-260-10).
q Pay out cable (TM 9-2320-260-10).
MATERIALS/PARTS
GENERAL SAFETY INSTRUCTIONS
Two locknuts
Wear hand protection when handling winch cable.
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
WARNING
Wear hand protection when handling winch cable. Broken wires
may cause injury to personnel.
NOTE
Maintain manual tension on hoist cable when removing block
q
from cable.
Winch block may be installed various ways for different loads.
This procedure covers two block rigging methods.
Remove locknut (3), screw (1), and block (4) from clevis (2). Discard locknut (3).
Install block (4) on clevis (2) with screw (1) and new locknut (3).
Remove locknut (7), screw (5), and clevis (10) from boom (6). Discard locknut (7).
1.
2. Remove cable (9) from block (8).
1. Install block (8) on cable (9).
2. Install clevis (10) on boom (6) with screw (5) and new locknut (7).
13-90






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.