CARGO BED COVER (CBC), TYPE IV, 5 T CARGO TRUCK, MTV, AND MTV TRAILER
Adjust the three turnbuckle bodies (1) until their respective CBC corner begins to rise, remove the support
(2) and measure each corner height from the top edge of the cable channel (3) that runs along the top
edge of the CBC lower section, to the interior roof surface of the CBC upper section. The height of all four
corners should be within +/- 1/8 inch using the winch corner (4) as a reference point. If the corners are not
equal, adjust the three turnbuckle bodies (1) until their respective corner is equal to the winch corner
height to within +/- 1/8 inch. Raise and lower the CBC upper section three to five times through
approximately 75 percent of its travel, checking and adjusting the height at each corner each time as
required to ensure that the height at each corner is to within +/- 1/8 inch.
Once all turnbuckles (1) have been adjusted, new turnbuckle locking clips (2) must be installed in the
turnbuckles (1). Using a pair of needle nose pliers slide the long end (straight portion) (3) of a new
turnbuckle locking clip (2) into the left end (4) of the turnbuckle body (1) positioned closest to the winch
corner. Install the bent end (5) of the turnbuckle locking clip (2) into the center hole (6) of the turnbuckle
body (1). Repeat for the right turnbuckle locking clip (7). Repeat turnbuckle locking clip installation
procedure for each turnbuckle body.