CARGO BED COVER (CBC), TYPE IV, 5 T CARGO TRUCK, MTV, AND MTV TRAILER
Lay the cables (1) in the channels (2) on the inside of the CBC, keeping the threaded ends (3) accessible.
Install the threaded end (3) of each terminal (rod end), one on the long cable and one on the short cable
going down each corner (other than the winch corner) into the tunbuckle body (4) removed earlier. Screw
the terminal ends (3) into the turnbuckle body (4) an equal amount until approximately 1/8 inch of thread
are still exposed. Repeat for each of the three turnbuckle bodies.
When screwing the terminal ends (3) into the turnbuckle body (4), be sure that the line (5) on the shaft of
the terminal end (3) is lined up EXACTLY with the small angled cutout (6) located on the edge of the
turnbuckle body (4). If the line (5) is not lined up exactly with the cutout (6), the locking pins (7) installed in
a later step will not install in the turnbuckle body.