TM 9-2320-366-20-5
This task covers:
a. Removal
d. Installation
b. Disassembly
e. Follow-On Maintenance
c. Assembly
INITIAL SETUP
Equipment Conditions
Materials/Parts
Batteries disconnected (para 7-57).
Dispenser, Pressure Sensitive Adhesive Tape
Air tanks drained (TM 9-2320-366-10-1).
(Item 20, Appendix D)
Booster Valve Removed (Para 11-5)
Ties, Cable, Plastic (Item 69, Appendix D)
Nut, Plain, Hex (Item 34, Appendix D)
Boot Kit, Exhaust (Item 3, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Parts Kit, Dehydrator (Item 218, Appendix G)
Goggles, Industrial (Item 15, Appendix C)
Nut, Self-Locking (4) (Item 168, Appendix G)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C)
Personnel Required
Socket Set, Socket Wrench (Item 34, Appendix C)
(2)
Purge Valve Tool (Item E-23, Appendix E)
Hammer, Hand (Item 18, Appendix C)
a. Removal.
WARNING
Air dryer may contain air pressure.
Loosen input air hose connector slowly to
vent off air pressure. Failure to comply
may result in injury to personnel.
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
(1)
Loosen input air hose nut (1).
(2)
Disconnect input air hose (2) from 90-degree fitting
(3).
(3)
Disconnect outlet air hose (4) from 90-degree fitting
(5).
Change 2
