TM 9-2320-366-20-5
(6) Remove two nuts (12), lockwashers (13), washers
(14), cover (15), and two washers (14) from
NOTE
Perform step (7) on vehicles equipped with
WTEC II transmission controllers.
terminal block TB1 (16). Discard lockwasher.
(7) Remove terminal lug TL22 (17) from terminal block
TB1 connector 58 (18).
NOTE
Perform step (8) on vehicles equipped with
WTEC III transmission controllers.
(8) Remove terminal lug TL22 (19) from terminal block
TB1 connector 58 (18).
NOTE
Perform steps (9) through (11) on vehicle
serial numbers 00001 through 11347
equipped with WTEC III controls.
(9) Remove terminal lug TL22(19) from wire 146 and
digitization power cable.
(10) Strip insulation 5/16 (8 mm) on wire 146.
(11) Install terminal lug (17) on wire 146.
Change 2
20-493
