TM 9-2320-366-20-5
This task covers:
a. Hydraulic Tubing Locations
b. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine shut down (TM 9-2320-366-10-1).
Dispenser, Pressure Sensitive Adhesive Tape
(Item 20, Appendix D)
Cap and Plug Set (Item 14, Appendix D)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Ties, Cable, Plastic (Item 60, Appendix D)
Pan, Drain (Item 24, Appendix C)
Oil, Lubricating, OE/HDO 10 (Item 42, Appendix
Goggles, Industrial (Item 15, Appendix C)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Crowfoot Attachment, Socket Wrench (Item 6,
a. Hydraulic Tubing Locations.
WARNING
Wear appropriate eye protection when working under vehicle due to the possibility of falling
debris. Failure to comply may result in injury to personnel.
Prolonged contact with lubricating oil (MIL-L-2104) may cause a skin rash. Skin and clothing that
come in contact with lubricating oil should be thoroughly washed immediately. Saturated clothing
should be removed immediately. Areas in which lubricating oil is used should be well ventilated
to keep fumes to a minimum. Failure to comply may result in injury to personnel.
CAUTION
Cap or plug tubes and connection points to prevent contamination of M1089 underlift hydraulic system.
Failure to comply may result in damage to equipment.
NOTE
Refer to Table 19-6. M1089 Underlift Hydraulic Tubing Locations for locations of hydraulic tubing on
the M1089 underlift. It may not be necessary to remove all hydraulic tubes at one time.
Tag tubes and connection points prior to removal.
Remove plastic cable ties as required.
Remove clamps and support brackets as required.
Position drain pan to collect oil.
