TM 9-2320-366-20-5
c. Cleaning/Inspection.
WARNING
Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use
only in well-ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors.
Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry
Cleaning Solvent is 100F (38C) and for Type II is 130F (50C). Failure to comply may result
in injury or death to personnel.
If personnel become dizzy while using Dry Cleaning Solvent, immediately get fresh air and medical
help. If Dry Cleaning Solvent contacts skin or clothes, flush with cold water. If Dry Cleaning
Solvent contacts eyes, immediately flush eyes with water and get immediate medical attention.
Failure to comply may result in injury or death to personnel.
(1) Clean metal parts with dry cleaning solvent.
NOTE
Replace any part that fails visual inspection.
(2) Inspect all parts for visible cracks or damage.
NOTE
Perform step (3) if personnel heater coil is to be
reused.
(3) Clean personnel heater coil (1) with soap and water.
WARNING
Compressed air used for cleaning
purposes will not exceed 30 psi (207 kPa).
Use only with effective chip guarding and
personal protective equipment
(goggles/shield, gloves, etc). Failure to
comply may result in injury to personnel.
(4) Dry personnel heater coil (1) with compressed air.
18-45
