TM 9-2320-366-20-4
(7) Position grille (11) on cab (3) with washer (12) and
screw (13).
(8) Position two washers (14) and screws (15) in grille (11).
(9) Tighten screw (13) to 48-60 lb-in. (5-7 Nm).
(10) Tighten two screws (15) to 24 lb-in. (3 Nm).
(11) Raise cab (TM 9-2320-366-10-1).
(12) Install clamp (16) on rear lights cable assembly (1).
(13) Install two clamps (16 and 17) on right frame rail (18)
with screw (19) and self-locking nut (20).
(14) Tighten self-locking nut (20) to 84-108 lb-in. (10-12 Nm).
(15) Route rear lights cable assembly (1) behind exhaust heat
shield (20.1).
(16) Tighten two screws (21) on exhaust heat shield (20.1).
Change 1
7-733
