TM 9-2320-366-20-4
(25) Lift dust boot (48) on terminal lug TL35 (49).
(26) Remove self-locking nut (50), washer (51), and
terminal lug TL35 (49) from voltage regulator (52).
Discard self-locking nut.
(27) Remove dust boot (48) from engine control cable
assembly (53).
NOTE
Perform steps (28) through (30) on vehicles
(28) Lift dust boot (54) on terminal lug TL110 (55).
(29) Remove self-locking nut (56), washer (57), and
terminal lug TL110 (55) from voltage regulator (52).
Discard self-locking nut.
(30) Remove dust boot (54) from engine control cable
assembly (53).
(31)
Disconnect connector clamp (58) from connector
P41 (59).
(32)
Disconnect connector P41 (59) from coolant temp-
erature gage sensor connector (60).
(33) Remove two self-locking nuts (61), screws (62), and
clamps (63 and 64) from clamps (65 and 66).
Discard self-locking nuts.
(34) Remove clamps (63 and 64) from engine control
cable assembly (53).
Change 2