TM 9-2320-272-24-4
NOTE
Perform steps 2 through 5 for left and right side of van body.
2.
Install two connector halves (1) on harness (23) and ceiling truss (2) with nut (3) and two
screws (25).
3.
Install cover (22) on van body (26) with six screws (241.
4.
Install two connector halves (18) on harness (23) and cover (22) with nut (19) and two screws (17).
5.
Install grommet (4) on van body (26).
6.
Install wires (7) and (8) on rear door blackout switch (6) with screws (5) and (9).
7.
Install wire (11) on relay (12) with screw (10).
8.
Install wire (13) on neutral bus (16) with screw (14).
9.
Install cover (20) on load center (15) with six screws (21).
Install hinged roof-operated blackout circuit plungers (para. 3-377).
FOLLOW-ON TASKS:
Retract van body sides (TM 9-2320-272-10).
5-601
