TM 9-2320-272-24-4
5-55. REAR COVER AND LOW PLANETARY CARRIER MAINTENANCE (Contd)
d. Assembly
1.
Install governor filter (6), O-ring (5), and filter plug (4) in rear cover (1). Tighten filter plug (4)
50-70 lb-ft (68-95 Nm).
2.
Install drain tube (2) and plug (3) in rear cover (1). Tighten plug (3) 12-16 lb-ft (16-22 Nm).
3.
Install plug (7) in rear cover (1). Tighten plug (7) 4-8 lb-ft (5-11 Nm).
NOTE
Perform step 4 only if support pin was previously removed.
4.
Using pin installer, press new governor support pin (11) into rear cover (1) until end of pin (11) is
5.886-5.896 in. (14.950-14.975 cm) from outside face (12) of rear cover (1).
NOTE
Perform steps 5 and 6 only if bearing and bearing race were
previously removed.
5.
Using bearing race installer, install bearing outer race (13) in rear cover (1).
NOTE
Install roller bearing before installing pin.
6.
Install roller bearing (10) and new pin (8) on low planetary carrier (14). Seat roller bearing (10) to
shoulder on shaft (9).
7.
Install new thrust washer (15) if discarded during inspection.
5-370
