TM 9-2320-272-24-4
5-55. REAR COVER AND LOW PLANETARY CARRIER MAINTENANCE
THIS TASK COVERS:
a. Removal
c. Cleaning and Inspection
d. Assembly
b. Disassembly
INITIAL SETUP:
MATERIALS/PARTS
APPLICABLE MODELS
Low clutch piston inner seal ring
All
SPECIAL TOOLS
Low clutch piston outer seal ring
Driver handle (Appendix E, Item 38)
Gasket (Appendix D, Item 228)
Spring compressor (Appendix E, Item 31)
Rear bearing installer (Appendix E, Item 115)
Crocus cloth (Appendix C, Item 20)
Oil-soluble grease (Appendix C, Item 53)
Driver handle (Appendix E, Item 37)
Seal remover (Appendix E, Item 92)
REFERENCES (TM)
Converter turbine bearing puller
TM 9-2320-272-24P
Pin remover (Appendix E, Item 94)
EQUIPMENT CONDITION
Bearing installer (Appendix E, Item 10)
`Iwo guide pliers (Appendix E, Item 59)
Transmission governor removed (para. 5-54).
Transmission output shaft oil seal removed
Tools
(para. 4-78).
General mechanic's tool kit (Appendix E, Item 1)
SPECIAL ENVIRONMENTAL CONDITIONS
Outside micrometer (Appendix-E, Item 80)
Work area clean and free from blowing dirt and
Vernier calipers (Appendix E, Item 159)
Spring tester (Appendix E, Item 131)
dust.
Torque wrench (Appendix E, Item 144)
Arbor press
a.
Removal
NOTE
Turn transmission housing with rear cover facing upward.
1.
Remove fourteen screws (1) and washers (5) from rear cover (2).
NOTE
Clean gasket remains from mating surfaces.
2.
Remove rear cover (2), low planetary carrier (9), gasket (4), and thrust washer (10) from
transmission housing (3). Discard gasket (4).
3.
Remove sleeve spacer (6), speedometer drive gear (7), and governor drive gear (8) from low
planetary carrier (9).
5-364
