TM 9-2320-272-24-4
5-54. TRANSMISSION GOVERNOR REPLACEMENT
THIS TASK COVERS
b. Installation
a. Removal
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
TM 9-2320-272-24P
All
EQUIPMENT CONDITION
TOOLS
First clutch removed (para. 5-53)
General mechanic's tool kit (Appendix E, Item 1)
Torque wrench (Appendix E, Item 146)
SPECIAL ENVIRONMENTAL CONDITIONS
MATERIALS/PARTS
Work area clean and free from blowing dirt and
dust.
Governor cover gasket (Appendix D, Item 241)
a. Removal
1.
Remove four screws (3), governor cover (4), and gasket (5) from transmission rear cover (2). Discard
gasket (5).
2.
Rotate transmission governor (6) clockwise to disengage, and remove transmission governor (6) from
transmission rear cover (2).
b. Installation
NOTE
Governor is properly seated only after counterclockwise rotation of
governor gear is felt during installation.
1.
Insert plastic gear (7) end of transmission governor (6) into transmission governor bore (1) and push
inward. Ensure governor (6) is properly seated.
2.
Install new gasket (5) and governor cover (4) on transmission rear cover (2) with four screws (3).
Tighten screws (3) 15-20 lb-R (20-27 Nm).
5-362
