TM 9-2320-272-24-4
5-7. CYLINDER LINERS AND BLOCK MAINTENANCE
THIS TASK COVERS:
c. Cleaning and Inspection
a. Removal
d. Cylinder Liners Installation
b. Disassembly
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
TM 9-2320-272-24P
M939/A1
SPECIAL TOOLS
EQUIPMENT CONDITION
Crankshaft and main bearings removed (para. 5-8).
Liner clamp set (Appendix E, Item 78)
Liner driver (Appendix E, Item 79)
GENERAL SAFETY INSTRUCTIONS
TOOLS
Keep fire extinguisher nearby when using
General mechanic's tool kit (Appendix E, Item 1)
drycleaning solvent.
Drycleaning solvent is flammable and toxic. Do
Cylinder liner puller (Appendix E, Item 107)
Outside micrometer (Appendix E, Item 80)
not use near an open flame.
Vernier calipers (Appendix E, Item 159)
When cleaning with compressed air, wear
eyeshields and ensure source pressure does not
Depth gauge (Appendix E, Item 81)
Gauge block (Appendix E, Item 52)
exceed 30 psi (207 kPa).
Dial indicator (Appendix E, Item 36)
SPECIAL ENVIRONMENTAL CONDITIONS
Telescoping gauge set (Appendix E, Item 136)
Torque wrench (Appendix E, Item 144)
Work area clean and free from blowing dirt and
dust.
Feeler gauge
Hold-down tool
MATERIAL PARTS
Two lockwashers (Appendix, Item 349)
Suction flange gasket (Appendix D, Item 680)
Two O-rings (Appendix D, Item 460)
Crevice seal (Appendix D, Item 88)
Drycleaning solvent (Appendix C, Item 71)
Antiseize tape (Appendix C, Item 72)
Lint-free cloth (Appendix C, Item 21)
Lubricating oil OE/HDO (Appendix C, Item 50)
Detergent (Appendix C, Item 27)
NOTE
Tag all cylinder liners for installation.
Remove six cylinder liners (1) from cylinder liner bores (2) with cylinder liner puller.
5-34
