TM 9-2320-272-24-3
1.
Install large side bracket (10) on roller bracket (14) with two screws (11), new lockwashers (9), and
nuts (8).
2.
Install small side bracket (15) on large bracket (14) with two new lockwashers (16) and
screws (17).
3.
Lightly coat two thrust washers (5) with grease and position on ends of roller (7).
4.
Install roller (7) and thrust washers (5) on roller bracket (14). Align holes in washers (5) and roller (7)
with holes in bracket (14).
5.
Align pin (13) holes in shaft (4) and bracket (14), and install shaft (4) on bracket (14) and through
roller (7).
6.
Install pin (13) in bracket (14) and shaft (4).
7.
Install grease fitting (12) in shaft (4).
4-845
