TM 9-2320-272-24-3
4-150. DUMP HYDRAULIC PUMP REPLACEMENT
Procedure for replacement of the dump hydraulic pump can be found in pare. 4-176.
4-151. DUMP CONTROL VALVE REPLACEMENT
Procedure for replacement of the dump control valve can be found in para. 4-178.
4-152, WRECKER BODY REPLACEMENT
THIS TASK COVERS:
a. R e m o v a l
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
MANUAL REFERENCES (TM)
TM 9-2320-272-10
M936/A1/A2
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
l Parking brake set (TM 9-2320-272-10).
Lifting device
l Crane turntable removed (para. 4-203).
Two chains
Two guide lines
GENERAL SAFETY INSTRUCTIONS
MATERIALS/PARTS
l Keep fire extinguisher nearby when using
Sixteen locknuts (Appendix D, Item 323)
drycleaning solvent.
Sixteen locknuts (Appendix D, Item 310)
l All personnel must stand clear during lifting
operations.
PERSONNEL REQUIRED
l Lifting device must have a weight capacity greater
Three
than the weight of the truck bed.
WARNING
Lifting device must have a weight capacity greater than the
l
combined weight of the truck bed to prevent injury or death to
personnel and damage to equipment.
l All personnel must stand clear during lifting operations. A
snapped cable, or swinging or shifting load, may result in injury
or death to personnel.
l Drycleaning solvent is flammable and toxic. Do not use near
open flame and always have a fire extinguisher nearby when
solvents are used. Use only in well-ventilated places, wear
protective clothing, and dispose of cleaning rags in approved
container. Failure to do this may result in injury or death to
personnel and/or damage to equipment.
NOTE
The left and right side body mounts are replaced the same. This
procedure covers the left side body mounts.
1.
Remove four locknuts (10), two U-bolts (11), and wood blocks from frame rail (3) and wrecker body (1).
Discard locknuts (10).
4-748
