TM 9-2320-272-24-3
4-95. TRANSFER CASE (M936/A1/A2) REPLACEMENT (Contd)
Position hydraulic jack and transfer case (8) under vehicle.
11.
Raise transfer case (8) in position high enough to allow for installation of mounting
12.
brackets (4).
Install two mounting brackets (4) on transfer case (8) with seven new locknuts (13). Tighten
13.
locknuts (13) 125-135 lb-ft (170-183 Nm).
Install right frame bracket (11) on frame (9) with three screws (12) and locknuts (10). Tighten
14.
locknuts (10) 120 lb-ft (163 Nm).
Place three insulators (5) between mounting brackets (4) and frame brackets (6).
15.
Slowly lower transfer case (8) and align holes in mounting brackets (4), insulators (5), and frame
16.
brackets (6).
Install three insulators (3), washers (2), screws (1), and new locknuts (7) on mounting
17.
brackets (4) and frame brackets (6). Tighten locknuts (7) 50-60 lb-ft (68-81 Nm).
Remove hydraulic jack from transfer case (8) and vehicle.
18.
Install cable clamp (21), new lockwasher (20). and ground wire (19) on frame (9) with screw (14) and
19.
new locknut (15).
4-544
