TM 9-2320-272-24-3
4-92. TRANSFER CASE TRANSORB DIODE REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
Two locknuts (Appendix D, Item 313)
Lockwasher (Appendix D, Item 371)
NOTE
Assistant will help with step 1.
1.
Remove locknut (9), washer (10), transorb diode ground wire (8), locknut (11), ground wire (7),
lockwasher (12), cable clamp (6), and screw (5) from frame (4). Discard locknuts (9) and (11) and
lockwasher (12).
2.
Disconnect transorb diode wire (2) from front wiring harness connector (1) and remove transorb
diode (3) from frame (4).
b. Installation
1.
Connect transorb diode wire (2) and transorb diode (3) to front wiring harness connector (1) between
frame (4).
2.
Install cable clamp (6), new lockwasher (12), and ground wire (7) on frame (4) with screw (5) and
new locknut (11).
3.
Install transorb diode ground wire (8) on screw (5) with washer (10) and new locknut (9).
4-524
