TM 9-2320-272-24-2
3-453. PRESSURE TRANSDUCER REPLACEMENT (Contd)
b. Installation
Install pressure transducer (11) on pneumatic controller (5) and connect wire (10) to pressure
1.
transducer (11).
NOTE
Perform steps 2 and 3 for vehicles without PTO.
Remove three screws (1) from mounting plate (3) and cab floor (4).
2.
Install cover (2) on mounting plate (3) and cab floor (4) with three new lockwashers (6) and
3.
screws (1).
NOTE
Perform steps 4 through 10 for vehicles equipped with PTO.
4.
Remove three screws (8) from mounting plate (3) and cab floor (4).
Install PTO control panel assembly (9) on mounting plate (3) and cab floor (4) with three new
5.
Install clevis (21) on shift lever (14) with clevis pin (13), washer (22), and new cotter pin (12).
6.
Install front winch control cable (18) on bracket (16) with spacer (17), clamp (20), two screws (19),
7.
and nuts (15).
Install clevis (28) on shift lever (23) with clevis pin (29), washer (24), and new cotter pin (25).
8.
Install PTO control cable (30) on bracket (32) with spacer (33), clamp (34), two screws (35), and
9.
nuts (31).
Install access cover (27) on shift panel (9) with six screws (26).
10.
3-1234