TM 9-2320-272-24-2
25.
Align holes in post assemblies (22) with holes in crossmember pads (17) and install lightweight
weapon station platform (1) on four post assemblies (22) with four washers (13) and screws (12).
26.
Install four spacers (16), roof mounts (18), plates (19), washers (20), and new locknuts (21) on four
screws (12). Do not tighten locknuts (21).
NOTE
Ensure locator tabs and lightweight weapon station platform are
aligned before tightening U-bolts.
27.
Tighten locknuts (9) and (7) 32-40 lb-ft (43-54 Nm).
28.
Tighten four locknuts (21) 15-20 lb-ft (20-27 Nm).
CAUTION
U-bolts and pins installed in steps 18 through 22 must be aligned
before tightening. Do not over-tighten or damage to cab will result.
29.
Tighten all screws and nuts that remain loosely installed from steps 2 through 19.
3-1183