TM 9-2320-272-24-2
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M929/A1/A2, M930/A1/A2, M931/A1/A2,
TM 9-2320-272-10
M932/A1/A2, M936/A1/A2
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
Parking brake set (TM 9-2320-272-10).
Air reservoirs drained (TM 9-2320-272-10).
MATERIALS/PARTS
Fifth wheel deck plate removed (M931/A1/A2,
Nine locknuts (M929/A1/A2, M930/A1/A2,
M932/A1/A2 only) (para. 3-251).
Battery ground cables disconnected (para. 3-126).
M931/A1/A2, M932/A1/A2)
(Appendix D, Item 327)
Five locknuts (M936/A1/A2)
(Appendix D, Item 327)
Locknut (M936/A1/A2) (Appendix D, Item 328)
Lockwasher (Appendix D, Item 413)
Ten tiedown straps (M936/A1/A2
(Appendix D, Item 694)
Five tiedown straps (M929/A1/A2, M930/A1/A2,
M931/A1/A2, M932/A1/A2)
(Appendix D, Item 694)
Antiseize tape (Appendix C, Item 72)
NOTE
Perform steps 1, 2, and 3 for M929/A1/A2, M930/A1/A2,
M931/A1/A2, and M932/A1/A2 vehicles.
1.
Remove tiedown strap (7) from tube (8) and ground wire (6). Discard tiedown strap (7).
2.
Remove tube (8) from elbow (9).
3.
Remove elbow (9) from tee (10) on wet reservoir (1).
4.
Disconnect wire (4) from thermostat connector (5) on air dryer (3).
NOTE
Perform steps 5, 6, and 7 for M936/A1/A2 vehicles.
5.
Remove tube (16) from wet reservoir adapter (18).
6.
Remove wet reservoir adapter (18) from wet reservoir (1).
7.
Remove three tiedown straps (15) from tube (16) and winch hydraulic line (17). Discard tiedown
straps (15).
8.
Remove locknut (14), clamp (13), ground wire (6), lockwasher (12), and screw (11) from right-side
frame rail (2). Discard locknut (14) and lockwasher (12).
3-1032
