TM 9-2320-272-24-2
3-281. WINDSHIELD WIPER RESERVOIR, JET, AND CONTROL REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP:
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-272-10
All
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
l Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
l Wheels chocked (TM 9-2320-272-10).
Three locknuts (Appendix D, Item 283)
Lockwasher (Appendix D, Item 370)
GENERAL SAFETY INSTRUCTIONS
Antiseize tape (Appendix C, Item 72)
Do not disconnect air lines before draining air
reservoirs.
a. Removal
WARNING
Do not disconnect air lines before draining air reservoirs. Small parts under
pressure may shoot out with high velocity, causing injury to personnel.
NOTE
Tag all air lines for installation.
Remove setscrew (13) and knob (14) from windshield wiper control (11).
1.
Remove nut (1), lockwasher (2), and windshield wiper control (11) from instrument panel (4).
2.
Discard lockwasher (2).
Remove clamp (10) and hose (12) from windshield wiper control (11).
3.
Remove hose (9) and elbow (8) from windshield wiper control (11).
4.
Remove clamp (6) and duct hose (5) from defrost duct (3). Pull duct hose (5) from firewall (7).
5.
Disconnect hoses (17) and (31) from jets (18) and (15).
6.
Remove wingnuts (19) and (33) and jets (18) and (15) from cab (32).
7.
8.
Remove hoses (17), (30), and (31) from tee (16).
Remove clamps (22) and (23) and hoses (12) and (30) from windshield wiper reservoir cap (24).
9.
Remove windshield wiper reservoir cap (24) from windshield wiper reservoir (25).
10.
Remove windshield wiper reservoir (25) from bracket (26).
11.
Remove three locknuts (29), screws (27), and bracket (26) from mounting bracket (28). Discard
12.
locknuts (29).
Remove grommets (20) and (21) and hoses (12) and (30) from firewall (7).
13.
b. Installations
NOTE
Wrap all male threads with antiseize tape prior to installation.
Install bracket (26) on mounting bracket (28) with three screws (27) and new locknuts (29).
1.
Install windshield wiper reservoir (25) on bracket (26).
2.
Install windshield wiper reservoir cap (24) on reservoir (25).
3.
Install hoses (12) and (30) on windshield wiper reservoir cap (24) with clamps (22) and (23).
4.
Insert hoses (12) and (30) through holes in firewall (7).
5.
3-758