TM 9-2320-272-24-1
3-201. WET AIR RESERVOIR (SUPPLY TANK) AND MOUNTING PLATE (M936/A1/A2)
REPLACEMENT (Contd)
8.
Remove four screws (1) and support plate (3) from frame (2).
9.
Remove elbow (20), shutoff valve (21), and elbow (22) from supply tank (14).
10.
Remove elbow (13) from supply tank (14).
11.
Remove elbow (9), relief valve (10), nipple (11), and reducer (12) from supply tank (14).
12.
Remove adapters (16) and (15) from supply tank (14).
13.
Remove adapters (7) and (4), safety valve (19), reducer (18), shutoff valve (5), tees (8) and (17), and
nipple (6) from supply tank (14).
b. Installation
NOTE
l If new reservoir is being installed, fittings from old reservoir
may be used. Fittings must be cleaned and inspected for cracks
and stripped threads.
Wrap male pipe threads with antiseize tape before installation.
l
1.
Install nipple (6), tees (8) and (17), shutoff valve (5), reducer (18), safety valve (19), and
adapters (7) and (4) on supply tank (14).
2.
Install adapters (15) and (16) on supply tank (14).
3.
Install reducer (12), nipple (11), relief valve (10), and elbow (9) on supply tank (14).
4.
Install elbow (13) on supply tank (14).
5.
Install elbow (22), shutoff valve (21), and elbow (20) on supply tank (14).
6.
Install support plate (3) on frame (2) with four screws (1).
3-558
