TM 9-2320-272-24-1
3-141. TRANSMISSION OIL COOLER AND MOUNT (M939A2) REPLACEMENT (Contd)
b. Installation
1.
Install splash panel extension (22) on bracket (25) and frame rail (19) with four screws (21), new
lockwashers (24), and new locknuts (23).
NOTE
Male pipe threads must be wrapped with antiseize tape before
installation.
Install new O-ring (12), washer (13), nut (14), and elbow (15) on oil cooler (11).
2.
Install new O-ring (8), washer (7), nut (6), and oil sampling valve (5) on oil cooler (11).
3.
Install oil cooler (11) on bracket (3) and splash panel extension (22) with four washers (10), screws (9),
4.
washers (10), and new locknuts (20).
Connect hoses (2) and (16) to oil cooler (11) and tighten clamps (1) and (17).
5.
Connect transmission oil lines (4) and (18) to oil sampling valve (5) and elbow (15).
6.
CAUTION
When filling cooling system, ensure drain valve on aftercooler is
open. Failure to do so may result in damage to equipment.
3-382
