TM 9-2320-272-24-1
3-133. TRANSMISSION OIL SERVICE INSTRUCTIONS (Contd)
CAUTION
Do not use gasket sealing compound when installing oil pan
gasket; oil leakage will result. If necessary, oil or light grease
coating may be used to hold oil pan gasket in position during
installation.
5.
Install new oil pan gasket (2) and oil pan (4) on transmission (1) with twenty-one screws (3).
6.
Tighten twenty-one screws (3) 10-15 lb-ft (14-20 Nm) in sequence shown.
NOTE
Due to gasket compression, torque values will be lost and screws
must be retightened.
7.
After oil pan gasket (2) is seated, loosen and retighten screws (3) 5 lb-ft (7 N-m) in sequence shown.
8.
Install dipstick tube (5) on transmission (1) with washer (8), clamp (6), and screw (7).
9.
Install dipstick tube (5) in oil pan port (12) with flare nut (11). Tighten flare nut (11) 10-25 1b-ft (14-
34 Nm).
10.
Install new tiedown strap (9) on dipstick tube (5) and tube (10).
d. Governor Filter Removal
WARNING
Drycleaning solvent is flammable and will not be used near open
flame. Use only in well-ventilated areas. Failure to do so may
result in injury to personnel.
Remove governor filter plug (13) and O-ring (14) from transmission (1). Discard O-ring (14) and
clean plug (13) thoroughly with drycleaning solvent.
CAUTION
Do not pry governor tilter from governor filter housing. Use thin,
pliable wire as a hook to reach into the housing to slide out
filter. Failure to do this will result in governor filter housing
damage.
2.
Remove governor filter (16) from governor fiber housing (15). Discard filter (16).
e. Governor Filter Installation
NOTE
Failure to properly install governor filter into governor filter
housing will greatly reduce its effectiveness.
1.
Install governor filter (16), with open end inserted first, into governor filter housing (16).
2.
Install O-ring (14) on governor filter plug (13).
3.
Install governor filter plug (13) in filter housing (15). Tighten governor filter plug (13)
15 lb-ft (20 Nm).
3-358
