TM 9-2320-272-24-1
3-131. WIRING HARNESS REPAIR
THIS TASK COVERS:
d. Plug Assembly
a. Terminal-Type Cable Connector
b. Male Cable Connector
e. Receptacle Assembly
c. Female Connector (With Sleeve)
INITIAL SETUP:
REFERENCES (TM)
APPLICABLE MODELS
All
TB SIG-222
TM 9-2320-272-10
TOOLS
TM 9-232-272-24P
General mechanic's tool kit (Appendix E, Item 1)
EQUIPMENT CONDITION
Electrical tool kit (Appendix E, Item 40)
Heat gun (Appendix E, Item 62)
l Parking brake set (TM 9-2320-272-10).
Soldering torch kit (Appendix E, Item 126)
Battery ground cables disconnected (para. 3-126).
l
GENERAL SAFETY INSTRUCTIONS
MATERIALS/PARTS
Solder (Appendix C, Item 70)
Do not wear jewelry when repairing harnesses.
Do not wear jewelry when repairing harnesses. Injury to personnel
may result if circuit is suddenly energized.
NOTE
If a wiring harness is damaged beyond repair, notify Direct
Support maintenance for replacement.
a. Terminal-Type Cable Connector
1.
Strip cable insulation (1) from cable (2) equal to depth of terminal well (4).
2.
Slide insulator (3) over cable (2).
3.
Insert cable (2) into terminal well (4) and crimp.
4.
Slide insulator (3) over crimped end of terminal (5).
3-349
