TM 9-2320-272-24-1
3-115. PROTECTIVE CONTROL BOX REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
General mechanic's tool kit (Appendix E, Item 1)
EQUIPMENT CONDITION
Torque wrench (Appendix E, Item 146)
l Parking brake set (TM 9-2320-272-10).
l Battery ground cables disconnected (para. 3-126).
MATERIALS/PARTS
l Ether cylinder and valve removed (para. 3-35).
Six lockwashers (Appendix D, Item 355)
1.
Remove windshield washer bottle lid (2) and washer bottle (3) from windshield washer bottle
bracket (4). Do not disconnect windshield washer hoses (1).
2.
Disconnect harness connector (12) from protective control box (13).
3.
Remove four screws (11), lockwashers (10), ground wire (9), protective control box (13), two
lockwashers (8), spacers (7), spacers (5), and washer bottle bracket (4) from firewall (6). Discard
lockwashers (10) and (8).
1.
Install washer bottle bracket (4) on firewall (6) with two spacers (5), new lockwashers (8),
spacers (7). protective control box (13). ground wire (9), four new lockwashers (10), and screws (11).
2.
Connect harness connector (12) on protective control box (13). Tighten connector (12) 10 lb-ft (14 Nm).
3.
Install washer bottle (3) and windshield washer bottle lid (2) on windshield washer bottle bracket (4).
3-304
