TM 9-2320-272-24-1
3-44. EMERGENCY STOP CONTROL CABLE MAINTENANCE
THIS TASK COVERS:
c. Installation
a. Removal
b. Inspection
INITIAL SETUP:
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-272-10
All
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
l Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
l Hood raised and secured (TM 9-2320-272-10).
l Battery ground cables disconnected (para. 3-126).
Locknut (M939/A1) (Appendix D, Item 313)
l Left splash shield removed (TM 9-2320-272-10).
Lockwasher (M939/A1) (Appendix D, Item 381)
Lockwasher (Appendix D, Item 354)
Lockpin (M939A2) (Appendix D, Item 271)
GAA grease (Appendix C, Item 28)
NOTE
Steps 1 through 4 are for M939A2 series vehicles.
Remove lockpin (10), washer (11), and cable pivot (4) from shutoff valve lever (1). Discard
1.
lockpin (10).
Remove screw (2), connector (3), and cable pivot (4) from cable (5).
2.
Remove screw (9), clamp (7), and cable conduit (6) from fuel bracket (8).
3.
Remove clamp (7) from conduit (6).
4.
NOTE
Steps 5 through 9 are for M939/A1 series vehicles.
Remove connector screw (18) and connector (19) from shutoff valve control lever (28) and cable (5).
5.
Remove connector (19) from stop control cable (5).
6.
Remove locknut (24), washer (25), and screw (21) from clamp (20) on conduit (6) and conduit clamp
7.
bracket (26). Discard locknut (24).
Remove screw (23), lockwasher (22), and clamp bracket (26) from engine (27). Discard lockwasher (22).
8.
Remove clamp (20) from conduit (6).
9.
NOTE
Steps 10 through 13 applies to all vehicles.
From behind instrument panel (15), remove nut (12) and lockwasher (13) on emergency stop
10.
control (14). Discard lockwasher (13).
Pull emergency stop control (14), conduit (6), and cable (5) through firewall (17), grommet (16), and
11.
instrument panel (151.
Remove grommet (16) from tirewall (17).
12.
NOTE
Perform step 13 only if replacing stop control cable.
Remove stop control cable (5) and handle of stop control (14) from conduit (6).
13.
3-130
