TM 9-2320-272-24-1
3-27. FUEL TANK (M936/A1/A2) MAINTENANCE
THIS TASK COVERS:
a. Draining
c. Inspection
b. Removal
d. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M936/A1/A2
FM 43-2
TM 9-2320-272-10
TOOLS
TM 9-2320-272-24P
General mechanic's tool kit (Appendix E, Item 1)
EQUIPMENT CONDITION
MATERIALS/PARTS
Parking brake set (TM 9-2320-272-10).
Two lockwashers (Appendix D, Item 358)
GENERAL SAFETY INSTRUCTIONS
Gasket (Appendix D, Item 144)
Gasket (Appendix D, Item 143)
Diesel fuel is flammable. Do not perform this
Gasket (Appendix D, Item 142)
procedure near flames.
Locknut (Appendix D, Item 299)
Three locknuts (Appendix D, Item 288)
Lockwasher (Appendix D, Item 379)
Antiseize tape (Appendix C, Item 72)
WARNING
Diesel fuel is highly flammable. Do not perform fuel system
procedures near open flame. Injury to personnel may result.
NOTE
The replacement procedure for right and left fuel tanks is basically
the same. This procedure covers the left fuel tank.
1.
Loosen fuel filler cap (2) at top of tank (1).
NOTE
Have drainage container ready to catch fuel.
2.
Remove drainplug (4) and gasket (3) from bottom of fuel tank (1). Discard gasket (3).
3.
After draining is complete, install new gasket (3) and drainplug (4) in fuel tank (1).
4.
Tighten fuel filler cap (2) on fuel tank (1).
b. Removal
1.
Loosen two nuts on screws (6) on wrecker body (5), and slide stop plate (7) upward.
2.
Remove outrigger (8) from body (5).
3.
Remove locknut (14), screw (9), washer (10), ground wire (11), and lockwasher (12) from left side of
frame (13) and double check valve (15). Discard locknut (14) and lockwasher (12).
3-84
