TM 9-2320-272-24-1
Table 2-2. Mechanical Troubleshooting (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
36. TRANSFER CASE LEAKING OIL
Step 1. Inspect drainplugs for leaks and looseness.
If loose and leaking, tighten drainplugs 35 lb-ft (48 Nm).
Step 2. Inspect transfer case housing for leaks.
If leaking, notify DS maintenance.
END OF TESTING!
37. EXCESSIVE NOISE
Check transfer case fluid level (LO 9-2320-272-12).
a. Fill to proper fluid level as necessary (LO 9-2320-272-12).
b. Tighten filler plug 35 lb-ft (48 N-m).
c. If problem still exists, notify DS maintenance.
END OF TESTING!
38. EXCESSIVE VIBRATION
Step 1. Check transfer case fluid level (LO 9-2320-272-12).
a. Fill to proper fluid level as necessary (LO 9-2320-272-12).
b. Tighten filler plug 35 lb-ft (48 Nm).
Step 2. Check yoke companion flange screws for proper torque.
Tighten screws 32-40 lb-ft (43-54 Nm).
END OF TESTING!
PROPELLER AND DRIVESHAFTS
39. EXCESSIVE NOISE OR VlBRATlON
Step 1. Check universal joints for proper lubrication.
Lubricate universal joints as necessary (LO 9-2320-272-12).
Tighten screws 32-40 lb-ft (43-54 Nm).
Step 3. Inspect propeller shafts for wear and damage.
Replace any worn or damaged propeller shafts (chapter 3, section VIII).
NOTE
Perform step 4 for M927 and M928 model vehicles.
Step 4. Inspect center bearing for looseness and damage.
a. Tighten center bearing-to-forward rear axle propeller shaft yoke to transfer-to-center
bearing rear flange screws 32-40 lb-ft (43-54 Nm).
b. If damaged, replace center bearing assembly (para. 3-150).
END OF TESTING!
2-78
