TM 9-2320-272-24-1
Table 2-1. Unit Preventive Maintenance Checks and Services (Contd).
NOT FULLY
MISSION
PROCEDURE
CAPABLE IF:
a. Inspect reservoir tanks, doublecheck valves, and
34
Semi-
Air
reservoir fittings for leaks (para. 2-15).
annual
and
b. Inspect condition of reservoir tank for damage that
doublecheck could cause leaks (para. 2-15).
valves
Check hydraulic oil level in tank. If low, fill to top notch
35
Semi-
Winch
annual reservoir on dipstick.
EXPECTED TEMPERATURES
+40F TO -65F
+40F TO -15F
ABOVE 15F
(+4C TO -54C)
(+4C TO -26C)
(ABOVE -9C)
OE/HDO 10
OE/HDO 30
OE/HDO
Lubricating oil, internal
combustion engine
(MIL-L-2104)
OEA
OEA
Lubricating oil, internal
combustion engine (arctic)
(MIL-L-46167)
WARNING
16 Semi-
Rear
wheels
annual
Completely deflate tire before removing from axle
and hubs,
if there is obvious damage to wheel components.
and
Injury or death to personnel may result from
suspension
exploding wheel components.
Use caution when inflating tires. Ensure tire is in
a tire cage and properly seated on rim before
inflating. An improperly seated tire can burst
with explosive force. Failure to comply can result
in death or serious injury to personnel.
Do not work on any component supported only
by lift jacks or hoist. Always use blocks or proper
stands to support the component prior to any
work. Equipment may fall and cause injury or
death to personnel.
Air in system is under pressure. Ensure engine
is shut down and all air reservoirs are drained
before disconnecting CTIS components to prevent
serious injury to personnel.
Do not allow grease or oil to contact brake linings.
Linings can absorb grease and oil, causing early
glazing and very poor braking action. Failure to
do so could cause serious injury or death to
personnel.
2-35
