TM 9-2320-260-34-2
17-19. PERSONNEL HEATER FUEL LINE AND BLOWER HOUSING REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-260-34P-2
All
EQUIPMENT CONDITION
TEST EQUIPMENT
Personnel heater igniter removed (para. 17-18).
Multimeter (Appendix B, Item 115)
TOOLS
General mechanic's tool kit
(Appendix B, Item 1)
Tool kit, electrical (Appendix B, Item 106)
NOTE
Fuel line and blower housing are replaced the same for early and
late model heaters. This procedure is for early model heaters.
a. Removal
1. Loosen nut (3) and remove fuel line (4) from fuel control valve (1).
2. Loosen nut (5) and remove fuel line (4) from burner fuel inlet (6).
3. Remove blower housing (2) from heat exchanger (7) and heater housing (8).
b. Installation
1. Place blower housing (2) in heater housing (8).
2. Install fuel line (4) on burner fuel inlet (6) through blower housing (2). Do not fully tighten nut (5).
3. Install fuel line (4) on fuel control valve (l). Finger tighten nut (3).
17-50
